 |
A COOPER TOOL CO.
Cooper Tools
PO Box 728
Apex, NC 27502
Phone - Northeast:
(919) 362-7540 | |
|
|
Wiss MetalMaster® Compound Action Snips |
|
The jaws of Wiss MetalMaster snips are made from extra-tough and wear-resistant special molybdenum steel to provide the extra service demanded by the
compound lever action and to withstand the severe strain of cutting heavy stock or tight curves.
The compound action multiples the force of the hand by 5 times.
The non-slip serrated jaws cut up to 18-gauge low-carbon, cold-rolled steel.
Available in three models, depending on the type of cut you are planning to make. |
 |
PART#: M1R
COST: $12.95
The M1R cuts left from tight curves to straight. Handles are formed of high strength steel with special non-slip, textured grips for superior control and comfort. | |
 |
PART#: M2R
COST: $12.95
The M2R cuts right from tight curves to straight. Handles are formed of high strength steel with special non-slip, textured grips for superior control and comfort. | |
 |
PART#: M3R
COST: $12.95
For general use, the M3R is recommended, because it cuts either moderate left, moderate right, or straight. Handles are formed of high strength steel with special non-slip, textured grips for superior control and comfort. | |
|
