Table Saw Laminate Blades
10" Coated Precision Crosscut / Laminate Saw Blade
by Freud Blades
COST: $89.99
80 HiATB tooth, 2° hook, 0.126" kerf, 5/8" arbor. Use for crisp, splinter-free and chip-free cuts in hard and soft woods. Flawless finish in veneered plywood, melamines & laminates. Perma-Shield coating guarantees less working friction and less resin adhesion while preventing the development of rust.
10" Coated Single Sided Laminate / Wood Saw Blade
by Freud Blades
COST: $94.99
80 TCG tooth, 5° hook, 0.126" kerf, 5/8" arbor. Long life, production blades for single-sided laminates, chip board and other manmade materials. Thses are the blades of choice for countertop fabricators and laminate flooring installers. Triple Chip Grind (TCG) tooth design will give excellent cuts in hard and soft wood and wood products. Perma-Shield coating guarantees less working friction and less resin adhesion while preventing the development of rust.
10" Coated Double Sided Laminate / Melamine Saw Blade
by Freud Blades
COST: $94.99
80 TCG tooth, -3° hook, 0.126" kerf, 5/8" arbor. Ultra long life and excellent finish on the top and bottom of laminates, melamines, and veneered plywood. Triple Chip Grind (TCG) tooth design with a negative hook angle provides superior life when cutting abrasive man-made materials. Perma-Shield coating guarantees less working friction and less resin adhesion while preventing the development of rust.
10" Coated Thin Kerf Double Sided Laminate / Melamine Saw Blade
by Freud Blades
COST: $69.99
80 TCG tooth, -3° hook, 0.091" kerf, 5/8" arbor. Ultra long life and excellent finish on the top and bottom of laminates, melamines, and veneered plywood. The thin kerf design is great for underpowered saws that need full kerf stability. Triple Chip Grind (TCG) tooth design with a negative hook angle provides superior life when cutting abrasive man-made materials. Perma-Shield coating guarantees less working friction and less resin adhesion while preventing the development of rust.
10" Duraline HI A/T Saw Blade
COST: $125.00
80 tooth, carbide-tipped, 40° high angle ATB, 5° hook, 1/8" kerf, 5/8" arbor. A great blade for cutting birch and oak ply veneers and low pressure lamnates such as melamine and vinyl over particle board. No need for a scoring set up as this blade cuts clean with no splintering or chip-out on top and bottom surfaces. Also recommended for fine cross-cutting on all woods.
